- Home
- About Changde
- Success Cases
Case Details
Magnet Steel Bonding for Magnetos
The magnet steel and bonding surfaces need to be cleaned to remove oil, rust and oxide layers to improve bonding. Steps may include degreasing, acid pickling, sandblasting and primer application to ensure the bonding interface is clean and has a certain roughness to increase mechanical keying
Details
The magnet steel and bonding surfaces need to be cleaned to remove oil, rust and oxide layers to improve bonding. Steps may include degreasing, acid pickling, sandblasting and primer application to ensure the bonding interface is clean and has a certain roughness to increase mechanical keying. The adhesive is applied evenly to the surface of the magnet steel or rotor core as required by the design, then the magnet steel is positioned accurately and appropriate pressure is applied to ensure the adhesive layer is evenly distributed and the magnet steel is in full contact with the substrate. Curing is carried out at the specified temperature and for the specified time to ensure the epoxy resin fully crosslinks and forms a high-strength bond layer. Sometimes staged heating or thermal cycling may be required to reduce internal stress.

